![]() ![]() ![]() I then proceed to setup on my control points and continue through the job with conventional (total station equipment) and closing out my traverse with GPS if it is open ended. I usually set up a GPS base and set control/locate street monuments using rapid static with the Triumph LS and Triumph-1 Base. I have taken GPS courses in school but they mainly focus on large GPS static projects which does not apply to me directly. I'm curious about the typical workflow that you would use for starting a new job from scratch, using both gps and conventional equipment for a boundary survey.ĭo you typically keep jobs on a grid or do you typically convert them to ground? I find myself going back and forth for different jobs but I think it would be better to have a consistent workflow so that I can become more efficient.Īs a new surveyor, I have not been able to find articles or books describing proper field methods for smaller boundary jobs. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |